What is flashing in construction

What is the difference between flashing and Counterflashing?

is that counterflashing is (construction) formed metal or elastomeric sheeting secured on or into a wall, curb, pipe or other surface, to cover and protect the upper edge of a base flashing and its associated fasteners while flashing is (roofing) components used to weatherproof or seal roof system edges at perimeters,

What is flashing and Counterflashing?

Counterflashing , also referred to as “cap” flashing , is the first line of defense against water infiltrating your building. This method uses metal cap flashing that is attached to the wall and sealed along the top edge with a bead of caulk.

What is meant by step flashing?

Step – flashing definitions (roofing) Individual pieces of sheet metal material used to flash walls, around chimneys, dormers and such projections along the slope of a roof . Individual pieces are overlapped and stepped up the vertical wall.

What is flashing on siding?

So what is flashing ? It’s a thin layer of waterproof material that keeps water from getting into places it doesn’t belong. If you wonder whether flashing has been installed the way it’s supposed to be, follow a drop of rain water as it moves down the side of your house.

Is roof flashing necessary?

Anyplace where the roof plane meets a vertical wall, such as a dormer, a chimney or a split-level roof , flashing is necessary . It’s not always possible to remove the old flashing in these spots, especially if the vertical wall is brick and the original flashing was grouted into the joints.

How much does step flashing overlap?

Place each step flashing piece about ¼ inch short of the bottom edge of the shingle that will overlap it — just enough so that the flashing piece is not visible when the overlapping shingle is in place.

You might be interested:  The construction of a production possibilities curve assumes

Do you need flashing for vinyl siding?

Straight lines are especially important on walls broken up by windows or doors. Wide window and door trim and inside corners can replace most J-channel, the hallmark of most bad vinyl jobs. A reliable drainage plane and thorough flashing are the weather barrier.